Announcement

Collapse
No announcement yet.

rod help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • rod help

    hello i have 2 12ft beach caster rods but the tips are very sensitive they are fine for casting but if there is any wind or sea on i can not tell if i have a knock or not is there any way i can make them strong as they are perfectly good rods would be a shame to leave them gathering dust

  • #2
    Youll not make it any stiffer mate over time it will eventually go a little bit more tippier (softer)

    Comment


    • #3
      Originally posted by gizmo1273 View Post
      hello i have 2 12ft beach caster rods but the tips are very sensitive they are fine for casting but if there is any wind or sea on i can not tell if i have a knock or not is there any way i can make them strong as they are perfectly good rods would be a shame to leave them gathering dust
      Don't know if they're any good,but i've seen some new bite alarm which was tested in one of the mags,tsf i think where the light goes red i think when
      you get a bite.Apparently it's green or whatever at other times,and will not accidentally turn red,even if the tips being blown about in a gale,so if it does
      go red,it's definitely a bite...I might have the colours the wrong way round,
      but you get the drift.

      Comment


      • #4
        dont know if this helps but if i think i have a bite i stand by me rod and take a bit of the main line between my fingers so its tight and you get the vibration down the line and you can tell if its the wind or a bite
        wind does knock the stiffest of rods but when you get knock you get a knock matey
        hope this helps bud

        Comment


        • #5
          dont know if this kelps but erm ..damn it al try again tomorrow a forgot
          Panel Pin Champ
          ........................

          Comment


          • #6
            Originally posted by codseeker View Post
            dont know if this kelps but erm ..damn it al try again tomorrow a forgot
            pmsl

            Comment

            Working...
            X