If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Is it advisable to either tig weld or braze a reel cage.
Just noticed my ultra mag 111 cage is detached from the reel seat on one side.
Looked on the internet and cannot get a spare cage, so its either repair or retire it.
Well TIG is normally for stainless steel? brazing for mild and carbon steel.
Is it stainless or just chrome-plated? It would be a nicer job if you could TIG it
Had a abu 7500 with the same issue due to it being dropped.I had it brazed on the underside of the reelseat.Fished whitburn with it for years,it never cracked or moved in any way.May not luck very pretty but it did the job.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment